|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-08-2005, 07:10 PM
|
#1 |
|
Registered User
Join Date: May 2005
Posts: 1
|
69 C10 question about spindle
I have a 69 C10 that I'm trying to finish a break job on. I found that the pass side wheel cylinder was trash and needed to be replace. The large bolt that holds the wheel cylinder in place was seized and had to be cut out. This must have been the reason the previous owner never had it replaced. I need a replacement bolt now to reassemble the brakes. Anyone have this item or a good spindle that they want to part with?
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
