almost a wheel stand... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

HvyChevy454 · 03-21-2002, 09:52 PM

i have been thinkin about the stregnth of the motor mounts though. I was thinkin about chaining 1 side down. Seriously though i only do it when im the first at the light, and nothing to the point of breaking it. I spent 3 yrs getting it built, there is no way I would ever hurt my baby. Too much blood and sweat into it. I am though waiting till i get a 1 piece shaft b4 i try it w/ the M/T's.

------------------
Lutz, Fl
My Team Website
The Heavy Chevy Website
------------------

72 Cheyenne 10 LWB GM 12-bolt 3.08 w/ Auburn Posi
91 454 Edel Intake 850 cfm carb Comp Cam 268/.500 Hedman Headers Dual 3'' Exhaust
71 Cheyenne 20 4x4 Fact. A/C PS PB Tilt Currently in the works...
Put it to the floor...

03-21-2002, 09:52 PM	#1
HvyChevy454 Slowly getting CRSS... Join Date: Jul 2001 Location: Lutz, Florida Posts: 656	i have been thinkin about the stregnth of the motor mounts though. I was thinkin about chaining 1 side down. Seriously though i only do it when im the first at the light, and nothing to the point of breaking it. I spent 3 yrs getting it built, there is no way I would ever hurt my baby. Too much blood and sweat into it. I am though waiting till i get a 1 piece shaft b4 i try it w/ the M/T's. ------------------ Lutz, Fl My Team Website The Heavy Chevy Website ------------------ 72 Cheyenne 10 LWB GM 12-bolt 3.08 w/ Auburn Posi 91 454 Edel Intake 850 cfm carb Comp Cam 268/.500 Hedman Headers Dual 3'' Exhaust 71 Cheyenne 20 4x4 Fact. A/C PS PB Tilt Currently in the works... Put it to the floor... __________________ -Nic Lutz, Fl My Team Website The Heavy Chevy Website ------------------ 72 Cheyenne 10 LWB GM 12-bolt 3.08 w/ Auburn Posi 91 454 Edel Performer RPM Intake 750 cfm carb Comp Cam 268/.495 Hedman Headers Dual 3'' Exhaust 71 Cheyenne 20 4x4 Fact. A/C PS PB Tilt Currently in the works... Speak Softly and Carry A Big Block... There is No replacement for Displacement... "If everything seems under control, you're just not going fast enough." - Mario Andretti

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.