What body bushings to use? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

orange72blazer · 01-11-2006, 04:15 PM

I'm going to be putting a 3" body lift on my Blazer and figured this would be a good time to replace the bushings. What kind of bushings are better the stock rubber type or the polyurthane bushings?

blazerparts · 01-11-2006, 07:02 PM

Some say poly's are stiffer and squeek, but they will probably outlast rubber. I used poly and greased them up good. Satisfied with them so far.

01-11-2006, 04:15 PM	#1
orange72blazer Registered User Join Date: Dec 2003 Location: West Michigan Posts: 447	What body bushings to use? I'm going to be putting a 3" body lift on my Blazer and figured this would be a good time to replace the bushings. What kind of bushings are better the stock rubber type or the polyurthane bushings? __________________ 1972 Chevy Blazer 1997 GMC Sierra 2009 Chevy Tahoe

01-11-2006, 07:02 PM	#2
blazerparts No,I DON'T have Tourett's Join Date: Mar 2005 Location: Reno, NV Posts: 556	Re: What body bushings to use? Some say poly's are stiffer and squeek, but they will probably outlast rubber. I used poly and greased them up good. Satisfied with them so far. __________________ '72 K5 CST 350/350 Daily Driver '69 GMC3500 Camper Special CST Flatbed 396/400 Upgraded to show truck '69 GMC 2500 L6292, 3spd beater

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.