![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: May 2004
Location: ND
Posts: 25
|
Cab to low driveshaft hits??
I bagged my 82 and when I dump the air out the the drive shaft hits the rear of the cab,it hits right at the very end of travel, is this normal. Do I have to put a channel in the rear of the cab for that, like I did for the gastank crossmember?
|
![]() |
![]() |
![]() |
#2 |
Commander Taco Bello
Join Date: Sep 2006
Location: Des Moines, Iowa
Posts: 2,232
|
Re: Cab to low driveshaft hits??
if it hits, i'd notch the cab.
by the sounds of it, you might be able to just take a heavy hammer and force the notch ![]() |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Sep 2006
Location: Midlothian, Tx
Posts: 144
|
Re: Cab to low driveshaft hits??
Your going to have to clearance it some way. I cut 4" out of the back of my cab for clearance. One of my friends had his drive shaft hitting like that and never did anything about, it broke a few months later.
|
![]() |
![]() |
![]() |
#5 |
Registered User
Join Date: May 2004
Location: ND
Posts: 25
|
Re: Cab to low driveshaft hits??
I might be able to just hammer it in, If not I guess its time to break out the saw
![]() ![]() |
![]() |
![]() |
![]() |
#6 |
Registered User
Join Date: Feb 2006
Location: northridge
Posts: 534
|
Re: Cab to low driveshaft hits??
you may be able to change the pinion angle to correct it depending on the type of setup you have
__________________
""A bagged vehicle is only as good as it's wheel/tire combo!" -getlowness! my build thread http://67-72chevytrucks.com/vboard/s...=223747:metal: I'M SO SO CAL! ![]() |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|