|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-20-2007, 04:28 PM
|
#1 |
|
Registered User
Join Date: Oct 2006
Location: Elgin, IL
Posts: 658
|
First time engine test
When i first bought my 66, it had sat fro a few years in a storage unit, nad now, after a few / 6 months of sittin in my garage, im finnally ready (i think) to try and start it up. I was wondering if u guys could tell me anything else i would need to do before i try and start it. What follows is a list of what ive done. Thanks guys.....
Filled with Collant New Oil and Filter New Spark Plugs New points and condensor New engine wiring harness "new" battery Fuel line is ran to in cab tank Anything else i chould do? Thanks again..... Brad
__________________
2000 GMC Sierra EXT Cab Short 4x4, finally mine... 1966 C10 SWB Fleet, 250 I6, three on the tree.... Previously Owned.... 1987 Chevy R10 "Silverado" (at least the badges were) Short Step 350 700r4.... 1972 Chevy LWB Fleet 350/350 EXTENDED CAB ALL THE WAY! .._..~...-...._...____ .._..-...______|_|__\____ ..-..~.|_(O)__|_|__|_(O)] |
|
|
|
04-20-2007, 05:14 PM
|
#2 |
|
Slots go on anything!
Join Date: May 2003
Location: Richardson, TX
Posts: 5,957
|
Re: First time engine test
Since it has been sitting that long, I would pull the distributor and prime the oil pump. That way there will be oil in the top end when you start it up.
|
|
|
|
|
04-20-2007, 06:39 PM
|
#3 |
|
Registered User
Join Date: Oct 2006
Location: Elgin, IL
Posts: 658
|
Re: First time engine test
ok cool, thanks
Brad
__________________
2000 GMC Sierra EXT Cab Short 4x4, finally mine... 1966 C10 SWB Fleet, 250 I6, three on the tree.... Previously Owned.... 1987 Chevy R10 "Silverado" (at least the badges were) Short Step 350 700r4.... 1972 Chevy LWB Fleet 350/350 EXTENDED CAB ALL THE WAY! .._..~...-...._...____ .._..-...______|_|__\____ ..-..~.|_(O)__|_|__|_(O)] |
|
|
|
|
04-22-2007, 10:57 PM
|
#4 |
|
Registered User
Join Date: Mar 2007
Location: Texas
Posts: 13
|
Re: First time engine test
Put the bigest filter you can find on the fuel line to catch the mice etc. when it comes out of that old gas tank!!! sitting that long it's gonna be "NASTY"
|
|
|
|
|
04-23-2007, 10:46 PM
|
#5 |
|
Registered User
Join Date: Mar 2007
Location: wyoming
Posts: 83
|
Re: First time engine test
A carb kit may not hurt.
|
|
|
|
|
04-24-2007, 03:55 AM
|
#6 |
|
Registered User
Join Date: Apr 2005
Location: Chula Vista, California
Posts: 495
|
Re: First time engine test
Just to be safe, pull the plugs and squirt some Marvel Mystery Oil into each sparkplug hole and let it sit and soak in for a day or two. When you are ready to turn the engine over do it by HAND!! Use a large breaker bar on the harmonic balancer bolt and see if the engine will turn over. If it does then your rings have not fused themselves to the cylinder walls. If the engine is loose, leave the plugs out and spin it over with the starter for about 30 seconds or so. This should spit out all of the Marvel Mystery Oil and get everything used to moving again. Reinstall plugs and wires, pour some fresh gas down the carb throat,(have a fire ext. handy) and see if she will light off. Good luck. RWG
__________________
rwgregory 67 GMC 2500 ,2w/d wide box 305 V-6, 4-speed |
|
|
|
|
04-24-2007, 06:58 PM
|
#7 |
|
Registered User
Join Date: Oct 2006
Location: Elgin, IL
Posts: 658
|
Re: First time engine test
The nice hting is that we got lucky and when we did the first turning a while back, it went fine, wdid the breaker bar thing then the started for a while. It worked nice. I also did bebuild the carb, and it seems ok, lol. Still havent tested it with gas, but sometime. Thanks for the input guys....
Brad
__________________
2000 GMC Sierra EXT Cab Short 4x4, finally mine... 1966 C10 SWB Fleet, 250 I6, three on the tree.... Previously Owned.... 1987 Chevy R10 "Silverado" (at least the badges were) Short Step 350 700r4.... 1972 Chevy LWB Fleet 350/350 EXTENDED CAB ALL THE WAY! .._..~...-...._...____ .._..-...______|_|__\____ ..-..~.|_(O)__|_|__|_(O)] |
|
|
|
|
04-24-2007, 09:46 PM
|
#8 |
|
Registered User
Join Date: Dec 2006
Location: Cleveland, Tx
Posts: 1,619
|
Re: First time engine test
my truck set for 2 or 3 years before i got it. i just changed the plugs and wires, oil, and cleaned the carb up, and it fired right up. engine had less than 5000 miles on it when it was parked though.
__________________
Respect: 1. A feeling of appreciative, often deferential regard; esteem. 2. The state of being regarded with honor or esteem. 3. Willingness to show consideration or appreciation. When you fail to show consideration to others values you are showing disrespect. |
|
|
|
|
04-24-2007, 10:18 PM
|
#9 |
|
Registered User
Join Date: Aug 2006
Location: Chicago
Posts: 38
|
Re: First time engine test
Ditto on having the fire extinguisher ready. I had flames lapping up the fire wall during the first startup of a new engine (flooded, gas dripping out headers caught fire) and it saved my skin.
It sounds like all the posts have pretty much covered all the possibilities. Might also visually check the spark at at least 1 cylinder with a spare plug just to ensure its intensity. Sounds like a lot of work took place around the plugs/points/battery/wire harness area- just to be sure there is spark before cranking for a long period. At any rate best of luck on the start-up. I personally prefer to wait until about 2:30am Sunday morning to perform this kind of work and have had excellent results doing it through open headers (just to keep the neighbors honest)! I believe they are secretly envious, but I could be wrong. Will the '66 see the road this summer? Best- S-D |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
