700r4 to Manual Conversion 4wd? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Russell · 06-12-2007, 10:31 PM

Options for 5 speeds include NV3500s and NV4500s.

NV3500s are not very tough, and will not last behind a 350 if you beat on the truck at all, NV4500s are extremely tough, but cost a lot. Both will take a 32 spline NP208, or NP241.

Regardless, you'll need your driveshaft lengths adjusted, a new tranny crossmember, high floor hump for a standard tranny (new carpet and insulation to match, if applicable), a set of standard pedals for a hydraulic clutch, and the hydro clutch stuff itself.

06-12-2007, 10:31 PM	#2
Russell Professional Grade Join Date: May 2003 Location: Fort McMurray, Alberta Posts: 7,915	Re: 700r4 to Manual Conversion 4wd? Options for 5 speeds include NV3500s and NV4500s. NV3500s are not very tough, and will not last behind a 350 if you beat on the truck at all, NV4500s are extremely tough, but cost a lot. Both will take a 32 spline NP208, or NP241. Regardless, you'll need your driveshaft lengths adjusted, a new tranny crossmember, high floor hump for a standard tranny (new carpet and insulation to match, if applicable), a set of standard pedals for a hydraulic clutch, and the hydro clutch stuff itself. __________________ 1995 Chevrolet 2 Door Tahoe (6.6L LBZ Duramax / ZF6 / NP241 with 1 ton solid axle swap)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.