|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
08-28-2007, 07:29 AM
|
#1 | |
|
Junior Member
Join Date: Jul 2007
Location: Odenton, Md
Posts: 552
|
Re: Just wanted to say thanks to all.....
Quote:
268 int./276 exh. Valve Lift with Factory Rocker Arm Ratio: 0.542 int./0.554 exh. lift Also the roller rockers are 1.7's (full rollers) Do you think that was a good one to get?? 
__________________
going to sell this one...looking for a SWB project next. Last edited by Jcentsr6; 08-28-2007 at 07:30 AM. |
|
|
|
|
08-28-2007, 04:30 PM
|
#2 | |
|
Sierra Grande Club
Join Date: Jan 2007
Location: New Mexico USA
Posts: 2,433
|
Re: Just wanted to say thanks to all.....
Quote:
That's one bigger than the one I got. I'm using 1.5 rollers. I'm not sure about using 1.6 on mine or what it even will do. The 1.7 is stock for big blocks, right? s/t
__________________
1971 GMC Sierra Grande, 1/2 ton short wide, original 4 bolt 010 020 block & heads. (matching #'s). 383 stroker, SMI q jet 750 cfm, Lunati Voodoo 60102 cam, Scorpion roller rockers, Spin Tech pro street mufflers with X pipe. 
|
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
