|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-26-2008, 04:36 AM
|
#7 |
|
Senior Member
 
Join Date: Nov 2007
Location: Greenville, SC
Posts: 873
|
Re: Tech: bed/bedstrip/bedside bolts
Great Tip!!
I had to grind out a steel plate that had been welded on top of the wood bed. That was bad enough. I got that out and thought I was done. Then I had to grind, torch, drill, bolt cut all the 1/4 inch bolts out, not a single nut worked. I wish I had your tip then. Interestingly the 8 bolts that hold the bed on we basically finger tight and came right off. Go figure. TR
__________________
1965 C10 SWB Fleet Two owner LS2 Swap Thread http://67-72chevytrucks.com/vboard/s...d.php?t=413880 |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode