|
02-28-2003, 08:25 PM
|
#1 |
|
Registered User
Join Date: Feb 2003
Location: Georgia
Posts: 16
|
Driveshaft Needed
I need a complete 2 piece drive shaft for my 1990 GMC Suburban 2wd. I'm told that 87-91 all will fit. Today I pulled one from a buddies 82 and it fit also. I have a very bad vibration problem. Swapped his into mine fixed the problem. He unfortunately insisted I give his back and so I need one badly. Anyone out there have one for sale.
__________________
1990 Suburban 94 Z28 92 Corvette "Boys and their Toys" http://www.libertyhillwebs.com/JW/ |
|
|
|
03-11-2003, 07:10 PM
|
#2 |
|
D.U.F. Member
Join Date: Nov 2002
Location: Huron/Brookings, SD
Posts: 288
|
Did you check your u-joints. They could just be bad, and causing your vibration. If so, it is an easy, and fairly cheap fix.
__________________
MEMBER OF THE DISCS UP FRONT CLUB '72 C-10 LWB Highlander, A/C, tilt TH350 w/ B&M shift kit, 327LJ bored .040", cast flattops, forged crank, L31 Vortecs, 9.25:1 CR, Comp conical valvesprings, Crane Energizer single pattern 216/.454", Professional Products Power Plus Crosswind intake, Edelbrock #1406 600cfm, HEI, dual exhaust, open 3.08 12bolt '68 C-10 4spd (not running) '79 C-10 LWB Mild 350 '80 Caprice Classic, 2-dr '97 GMC K-1500, SWB, Reg. Cab, Z-71, 5.7, Auto |
|
|
|
|
03-12-2003, 05:58 PM
|
#3 |
|
Registered User
Join Date: Feb 2003
Location: Georgia
Posts: 16
|
Yeah I checked them first, found a driveshaft finally. the rear portion was causing the problem. Replaced the carrier bearing as well. All is good to go now. For that part at least. Thanks for the reply.
__________________
1990 Suburban 94 Z28 92 Corvette "Boys and their Toys" http://www.libertyhillwebs.com/JW/ |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
