|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-22-2009, 02:52 PM
|
#1 |
|
Registered User
Join Date: Jul 2005
Location: Riverside CA
Posts: 860
|
ok so i want to be cheap
I think i have probably asked this a few times, but how do i remove the bushings on a 4 link without destroying them?
I have heard torch them but that is not an option. My pile of parts is hitting the powdercoaters next week, but i do not want to buy new bushings for a 4 link that has never seen the road. I figure 8x10each, i can something else for my truck. |
|
|
|
05-22-2009, 03:50 PM
|
#2 | |
|
Registered User
Join Date: Aug 2008
Location: Pittsburg, KS
Posts: 2,466
|
Re: ok so i want to be cheap
Quote:
You should be able to just hammer or press them out. It shouldn't be to much of a pain. just us a socket thats the size of the metal sleeve and set the end on top of a vise. Then tap out the sleeve with the socket and hammer. The bushings should then come out eaisly. Did that make any sense?
__________________
Doug Looking for a 67-72 short bed driver..... |
|
|
|
|
|
05-22-2009, 04:29 PM
|
#3 |
|
Saving 1 truck at a time!
Join Date: Aug 2001
Location: Kent, WA
Posts: 6,465
|
Re: ok so i want to be cheap
Makes sense to me...but then I have done that more than a couple of times!!!!
__________________
'68 C20 Longhorn 50th Anniversary 400/TH400 '68 C20 Longhorn 50th Anniversary 468/TH400w/buckets '72 C20 Halfhorn (Longhorn w/o cab and front clip) '69 Flxible Cruiser (look up ugly in the dictionary) |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
