TH350 shift linkage - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Big Fenders · 07-23-2009, 07:05 PM

I installed my engine and trans yesterday and am now trying to figure out shift linkage. I did get a junk yard linkage with frame mount pivot bracket. The actual shift rod was too short so I welded on about 4 more inches of rod. It doesn't want to completely go to the park position or its better to say that it doesn't want to stay in the park position. My shop manual covers Power Glide and heavier automatics so actually not much help. This is a 350 - 350 install. Any help or on-line manual reference appreciated.
Bob

07-23-2009, 07:05 PM	#1
Big Fenders Registered User Join Date: Mar 2008 Location: Tucson Arizona Posts: 264	TH350 shift linkage I installed my engine and trans yesterday and am now trying to figure out shift linkage. I did get a junk yard linkage with frame mount pivot bracket. The actual shift rod was too short so I welded on about 4 more inches of rod. It doesn't want to completely go to the park position or its better to say that it doesn't want to stay in the park position. My shop manual covers Power Glide and heavier automatics so actually not much help. This is a 350 - 350 install. Any help or on-line manual reference appreciated. Bob

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.