![]() |
![]() |
#1 |
Registered User
Join Date: Mar 2010
Location: Cullman Alabama
Posts: 56
|
Intake
Will my stock Q-jet fit on a new edelbrock intake?
Thanks
__________________
71 ![]() |
![]() |
![]() |
![]() |
#2 |
Between Trucks...
Join Date: Mar 2002
Location: Los Angeles, CA.
Posts: 3,830
|
Re: Intake
Depends on which intake. You want an intake that accepts a spreadbore carb. Also the intake might not have provisions for divorced choke on the carb.
__________________
Beat it to fit, Paint it to match... ![]() Last edited by Sinister; 03-27-2010 at 04:26 PM. |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Mar 2010
Location: washington
Posts: 274
|
Re: Intake
you could always run the adapter on it if it doesn't
|
![]() |
![]() |
![]() |
#4 |
What?
Join Date: Jun 2007
Location: Southern California
Posts: 7,617
|
Re: Intake
I ran a Q-jet on a Performer for years, and had great luck with that set up.
Though I do remember being picky about base gaskets, IIRC I tended to use the base gasket that was thick cardboard material. Just be sure that you have good seal contact, since the thin flimsy gaskets never worked well for me.
__________________
Chris 1968 K20 Suburban 1972 K10 LWB PU |
![]() |
![]() |
![]() |
#5 |
20' Daredevil (Ret)
![]() Join Date: May 2003
Location: Jefferson State
Posts: 13,811
|
Re: Intake
My Q-jet has been sitting on an Edelbrock 2101 Performer for quite a few years with no issues.
__________________
- Mike - 1972 K20 LWB 350/350/205 RIP El Jay |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|