Swapping drop spindles for stock? DIY?

[73chevyman]

done this kinda of job on my uncles monte and all we did was the jack thing it worked well and had no problems... you just need to lower enough to get the spindel out and put the new one in... just make sure the jack is in a sucure spot on the lca and everything will be fine..... not a hard job just take your time and it will all fall into place.... i also know to much precaution will also get you hurt never be scared to get into a job if so take it to a professional and the worries are gone... like said above you'll have to drop the lca alot to get the spring out.... if i were closer i'd give you a hand and call it a day good luck