|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-30-2011, 10:26 AM
|
#1 |
|
Registered User
Join Date: Aug 2010
Location: West Chicago, IL
Posts: 24
|
Removing a Fleetside rear bed cross sill
This is a dumb question, but how do you remove the rear bed cross sill from the Fleetside bedsides? Is it just bolted on or welded and bolted? I've done this in the past and it ended up being a butcher job due to rust and welds. My current bedsides and rear sill are too nice to mess up. It will make bodywork so much easier having this apart. Thanks.
 
__________________
The dude abides. |
|
|
|
04-30-2011, 10:52 AM
|
#2 |
|
Senior Member
Join Date: Aug 2005
Location: Greenwell Springs, Louisiana
Posts: 2,882
|
Re: Removing a Fleetside rear bed cross sill
4 bolts on each side, and 2 spot welds to grind. One spot weld on top of the cross sill where the bedside and wood meets. Wish i had a pic.
Last edited by 62 short step; 04-30-2011 at 10:58 AM. |
|
|
|
|
04-30-2011, 11:07 AM
|
#3 |
|
Senior Member
Join Date: Aug 2005
Location: Greenwell Springs, Louisiana
Posts: 2,882
|
Re: Removing a Fleetside rear bed cross sill
And a spot weld here. If you can see the red mark.
|
|
|
|
|
04-30-2011, 12:58 PM
|
#4 |
|
Registered User
Join Date: Aug 2010
Location: West Chicago, IL
Posts: 24
|
Re: Removing a Fleetside rear bed cross sill
Thanks
__________________
The dude abides. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
