Wheel wells for 67-72 - Page 2 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Hill's Rod & Custom · 05-17-2011, 10:46 PM

Check out these wheel wells for a slammed 67-72. They are in the process of being made from fiberglass and the first ones will be ready for sale in a month. Both front and rear wheel wells look like a factory GM set, but raised enough to make a low stance. The blazer below is at ride height and has lots of suspension travel! I have been surfing this site for years and enjoy the information and vendors I have found. When these become available I'm going to become a vender on this site. I welcome any feed back you might have.

05-17-2011, 10:46 PM	#1
Hill's Rod & Custom Registered User Join Date: May 2011 Location: California Posts: 55	Wheel wells for 67-72 Check out these wheel wells for a slammed 67-72. They are in the process of being made from fiberglass and the first ones will be ready for sale in a month. Both front and rear wheel wells look like a factory GM set, but raised enough to make a low stance. The blazer below is at ride height and has lots of suspension travel! I have been surfing this site for years and enjoy the information and vendors I have found. When these become available I'm going to become a vender on this site. I welcome any feed back you might have. Attached Images Last edited by Hill's Rod & Custom; 05-18-2011 at 12:04 AM. Reason: more pictures

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.