|
10-16-2011, 10:02 PM
|
#1 |
|
Registered User
Join Date: Apr 2010
Location: alabama
Posts: 111
|
One Piece Driveshaft
Is there any driveshaft out of another truck that will fit in a 86 2wd swb if i put a short tail 350 in it. Thanks
|
|
|
|
10-17-2011, 08:46 AM
|
#2 |
|
Robert Olson Transport
 
Join Date: Oct 2002
Location: recent transplant to NC USA
Posts: 20,310
|
Re: One Piece Driveshaft
none im aware of.. its prolly a custom made one youll need
__________________
Bob 1951 International running on a squarebody chassis "If a man's worth is judged by the people he associates himself with, then i am the richest man in the world knowing some of the fine people of this board" http://67-72chevytrucks.com/vboard/a...t.php?f=25&a=9 (you can review the site rules here!) PM Me for your vehicle/parts hauling needs in the North East US or see my Facebook page Robert Olson Transport Live each day to the fullest.. you never know when fate is going to pull the rug out from under you... I hate cancer!! |
|
|
|
|
10-17-2011, 10:54 AM
|
#3 |
|
Registered User
Join Date: Aug 2011
Location: Winnsboro TX
Posts: 234
|
Re: One Piece Driveshaft
What are you pulling out? Can't remember if it was a short tail, but I swapped a 350 for a 700r4. Folks kept saying I'd probably have to get the shaft shortened, but I got lucky and it fit right in.
Find a driveshaft shop where you're at and give them a call. Ask them what measurement they'll need. I would think you could get a little longer one and have them cut it down. Heck, you might get lucky and they have something laying around the shop for cheap.
__________________
1st - '68 long bed 2nd - '81 SWB Now - '86 SWB, Edelbrock 1406/stock 350/700r4 |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
