IRON DUKE chanes head gasket now runs very rough

[Jon Scully]

Originally Posted by truckdude239

http://www.hotrodders.com/forum/valv...5-a-23075.html CHECK THIS OUT

Thanks! I had read this last night-- from my manual/etc I think I set it properly. But I will check tomorrow. The one mistake I may have made: I did not realize that each cylinder had to be set to TDC to torque the bolts down for its' rockers. I hope I did not screw up the cam. A stated before, I only let her run a few seconds per shot (3 times).

I will get the valve cover off tomorrow, and have a look see--

All of you advice is welcome-- This board is such a wealth of knowledge. I used to work in a forklift shop; but have since changed career paths...so It is great to have a place to come and chat about these things!!!