|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-29-2011, 08:44 PM
|
#5 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Lower A arms snubber question
I measured the metal thickness on both A arms and they are the same, .187".
I compared the two A arms again very closely and the only difference that I can see is the snubber stands. Seems very strange that the A arms would work without the snubbers. The stands also act as steering stops! Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC Last edited by JimKshortstep4x4; 11-29-2011 at 08:44 PM. Reason: Added wording. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode