|
09-20-2003, 09:16 PM
|
#1 |
|
Registered User
Join Date: Jun 2003
Location: central florida
Posts: 116
|
engine switch
I have a 69 c-10 2wd with 245 six cyln and three on a tree, all factory. I have a 305 V-8 that is now hookewd up to an auto trans. I want to installl the 305 with a 4spd Saginaw manual trans. Do I need to get different flywheel and housing, or will the six cyln fit?
|
|
|
|
09-20-2003, 09:33 PM
|
#2 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
the clutch pcs from your 250 will bolt right on the 305. good luck,crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
|
09-20-2003, 10:54 PM
|
#3 |
|
Registered User
Join Date: Jan 2003
Location: Santa Fe, Texas
Posts: 249
|
is the 6cyl 3 on the tree the same as a 350? if so I might be intrested in your 3 speed and parts if you do the swap.
|
|
|
|
|
09-21-2003, 12:31 AM
|
#4 |
|
Registered User
Join Date: May 2003
Location: Shreveport LA
Posts: 3,170
|
Be sure you put a pilot bearing in the crank.
|
|
|
|
|
09-21-2003, 07:25 AM
|
#5 |
|
Registered User
Join Date: Jun 2003
Location: central florida
Posts: 116
|
engine switch
Thanks to all that responded. It appears I was right and my friend wrong... haha!
Locutus, I am not going to do this for a couple months, and I am not sure if it will fit. DC |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
