|
09-24-2012, 06:00 PM
|
#1 |
|
Registered User
Join Date: Jul 2010
Location: Pennsylvania
Posts: 87
|
sag 4 speed
hey guys i got a saginaw 4 speed i put in my truck ! for some reason it keeps leeking gear oil out of the front behind the flywheel! im positive its not the rear main leaking oil cause i just replaced it! plus its been leaking before that! any ideas is there a front seal?
|
|
|
|
09-24-2012, 06:58 PM
|
#2 |
|
Registered User
Join Date: Jan 2007
Location: Topeka,KS
Posts: 778
|
Re: sag 4 speed
There should be a input shaft seal pressed into the front bearing retainer. And a gasket for the front bearing retainer. Should be just 4 bolts holding it on. When you pull it off make note if there is a weep hole or a channel and where it's oriented, they usually go down to allow gear oil to drain back into the case.
__________________
68' C20. 283CI w/55CC 305HO heads, NP435 Close Ratio, Corp. 14 bolt FF 3.21, 75' front end swap (everything but the X-member). |
|
|
|
|
09-24-2012, 08:24 PM
|
#3 |
|
Registered User
Join Date: Aug 2009
Location: Bowser
Posts: 13,752
|
Re: sag 4 speed
While you got it apart replace the clutch. With a rear main and a snout seal leaking your disc is likely toast or close to it.
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
