|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-04-2012, 11:07 AM
|
#1 |
|
Registered User
Join Date: Oct 2012
Location: Aubery Texas
Posts: 2
|
1/2 ton suburban body on 3/4 ton suburban frame
thinking about mounting my 1979 1/2 ton body on a 1978 3/4 ton frame will this be a clean swap or am i looking at a bunch of mods. How about a book on GM frames and body parts what fits what anybody seen one of those out there.
|
|
|
|
11-04-2012, 11:38 AM
|
#2 |
|
resident wrencher
Join Date: Dec 2006
Location: ramona california
Posts: 720
|
Re: 1/2 ton suburban body on 3/4 ton suburban frame
The two should fit as long as there both burbs idk I truck frames are the same as burbs but should be a direct swap unless te frame is an 81+ there sligtly different
Posted via Mobile Device |
|
|
|
|
11-04-2012, 11:42 AM
|
#3 |
|
Registered User
Join Date: Dec 2010
Location: Pittsburgh, PA
Posts: 1,009
|
Re: 1/2 ton suburban body on 3/4 ton suburban frame
It will bolt right up, no problems at all. Make sure the transmissions are the same, or you may have to mess with linkage. Other than that, it's plug and play.
__________________
Steve Member of the Foot Pedal Club '83 Chevy K20: 6" Rough Country, 3" Performance Accessories BL, Bushwacker Cutouts, 38x15.50 Mickey Thompson Baja Claws, 350 HP 350 crate engine from Jegs, Turbo 400 
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
