Problems with 1961 rear differential...need advice

[MusicMan70]

par4tom,

I had my unit gone thru by a reputable transmission shop. I can only assume some type of sealant was used. I have not had any leakage issues and followed the instructions from the Classic's Truck article.

[par4tom]

Another question...I have secured a cast-iron NP 440 transmission (off a 4 wd), and the transmission shop is going to completely go through everything once I give them the go ahead. The only thing missing is the tail housing for a 2wd which the guy is trying to track down.

He is also going to machine down the bearing retainer to 4 11/16 to fit the bell housing. So in that regards, I'm making progress. ("Thanks" for the pictures)

Can anyone point me to finding a tailhousing for this? Or, can you let me know what specific tailhousing I will need here?

And I would like to confirm, it is a 10 spline on the OUTPUT shaft as well, correct?

[MusicMan70]

Well here is a complete unit...

http://www.ebay.com/itm/Chevrolet-4-...df9545&vxp=mtr

... with shifter and HD shift rods and bellhousing. This is what you will need and it has the correct tailhousing AND Shifter too, cheaper as well, should you decide to go this route.

Output shaft towards engine is 10 spline; to driveshaft I think is the same as a turbo 350 (30 spline?)

Here are some tailshaft pics

[Captainfab]

I assume that the trans guy has verified that the output shaft is the correct length and spline for a 2wd application? Typically when converting a 4wd trans to a 2wd trans, the output shaft has to be changed also. This may or may not be the case with this trans. Just trying to make sure you don't end up with something you can't use.

[par4tom]

I went over to his shop this morning and he was pleasantly surprised with all the homework I had done (thanks to you guys!)

Anyway, the input shaft is correct and should fit. He knows that the bearing retainer needs to be machined down to 4 11/16 to fit. So on the front end, we're good.

On the tail, evidently there are numerous tail housing units that will fit this transmission and I'll let you know which one he decided to use.

I'll document this whole install and post it on here once I'm done and maybe it can help someone else.

But from what he can see from the pictures on this thread and from what I've told him, we appear to be good to go. I ordered the transmission today and it should be up to Fresno from LA here in the next couple of weeks.

[par4tom]

Ok, I'm stuck.

The transmission guy says he is having trouble finding a tail housing to fit a cast iron NP440/MY6.

Can someone help me on which tailhousing(s) will fit?

Tom
Posted via Mobile Device

[MusicMan70]

Tom, Is the bolt pattern different then the posted photos? If so can he send you a pic of the bolt pattern?