|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-01-2013, 01:20 AM
|
#26 |
|
Registered User
Join Date: Oct 2010
Location: El Mirage AZ
Posts: 169
|
Re: Rough idle while in gear???? Almost stalls
I got the intake off and everything cleaned up again, and I put a longer straight edge on the intake and it seems on the passenger side I have a bunch of clearance on a couple of the intake runners, this might be part of my sealing troubles, I might go grab another intake and check it's clearance and compare the two, anyone know what's an acceptable clearance on these?
Posted via Mobile Device |
|
|
|
06-01-2013, 07:09 PM
|
#27 |
|
laying low
 
Join Date: Mar 2001
Location: Searcy, Ark. USA
Posts: 13,543
|
Re: Rough idle while in gear???? Almost stalls
Not much more than the thickness of the gasket I'm sure though off hand I don't recall that gasket thickness. Another thought, see if there are thicker gaskets available.
__________________
Boog 69 Chevy stepside, 358/T350, 4.11 posi, 4.5/4 drop, rallys, poboy driver primer is finer 91 Chevy sportside, Tahoe, Yukon & GMC Crewcab All GM..'nuff said. I stand for the flag and kneel at the cross |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
