Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
07-13-2013, 01:33 PM | #1 |
Registered User
Join Date: May 2007
Location: Frisco, TX
Posts: 80
|
Wha frame stands did i pull??
This is a 63 c10. when i first pulled the 250 out i left the frame stands on it while i worked on the crossmember swap. well i sold the motor, and didnt even think about pulling the frame stands back off.
I went to the junk yard and found a early 80s suburban and these mounts were easy to access so i pulled them. well i get them home and find this... what is the deal here? |
07-13-2013, 02:46 PM | #2 |
Registered User
Join Date: Dec 2009
Location: Independence Mo
Posts: 4,119
|
Re: Wha frame stands did i pull??
'63 and early '80's are not a direct swap, you need to move the mount down and drill some new holes to bolt them in.
__________________
My '72 short bed build. http://www.ls1tech.com/forums/conver...6-0-4l80e.html 5.3 swap into my RUSTY '71 C10 http://ls1tech.com/forums/conversion...71-c-10-a.html |
07-13-2013, 04:09 PM | #3 |
Registered User
Join Date: May 2007
Location: Frisco, TX
Posts: 80
|
Re: Wha frame stands did i pull??
thats what i figured, so like that third pic... drill it in right there, right?
|
07-13-2013, 04:28 PM | #4 |
Registered User
Join Date: Dec 2009
Location: Independence Mo
Posts: 4,119
|
Re: Wha frame stands did i pull??
That's what I would do.
Posted via Mobile Device
__________________
My '72 short bed build. http://www.ls1tech.com/forums/conver...6-0-4l80e.html 5.3 swap into my RUSTY '71 C10 http://ls1tech.com/forums/conversion...71-c-10-a.html |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|