Raising wood bed floor - The 1947 - Present Chevrolet & GMC Truck Message Board Network

67ctener · 03-08-2014, 10:46 PM

There's tons of threads on the topic but haven't found anything that involves raising a floor only about 2". Most threads I've found people are raising 8" or more. Any creative ideas to raise the floor 2" with minimal modify and fabrication? This is all just to get my axle to sit in my in frame notch when aired out. Any ideas/pictures would be appreciated.

67ctener · 03-08-2014, 10:53 PM

The bottom of that cross sill represents where the bottom of the wood will be

03-08-2014, 10:46 PM	#1
67ctener Registered User Join Date: Oct 2012 Location: Arlington Washington Posts: 1,808	Raising wood bed floor There's tons of threads on the topic but haven't found anything that involves raising a floor only about 2". Most threads I've found people are raising 8" or more. Any creative ideas to raise the floor 2" with minimal modify and fabrication? This is all just to get my axle to sit in my in frame notch when aired out. Any ideas/pictures would be appreciated.

03-08-2014, 10:53 PM	#2
67ctener Registered User Join Date: Oct 2012 Location: Arlington Washington Posts: 1,808	Re: Raising wood bed floor The bottom of that cross sill represents where the bottom of the wood will be Attached Images

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.