The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Engine & Drivetrain > LSx Swaps

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 03-24-2014, 07:31 PM   #1
Dubnova
Registered User
 
Join Date: May 2012
Location: Madison Alabama
Posts: 201
6L80E LS3 Swap in 65 C10?

Can anybody tell me if it's possible to swap a LS3 with a six speed 6L80e trans into 65 C10 without cutting up the floor pan with a low hump?

Last edited by Dubnova; 03-24-2014 at 07:37 PM.
Dubnova is offline   Reply With Quote
Old 03-24-2014, 08:47 PM   #2
First c10
Registered User
 
First c10's Avatar
 
Join Date: Dec 2012
Location: Los Banos CA
Posts: 2,705
Re: 6L80E LS3 Swap in 65 C10?

In my 70 wth a low hump I had to stretch it. By pushing up on the center of the hump with a big pipe and floor jack, and then used a dead blow hammer to bump the sides in to make a hump with a curve. I gained about 1" pretty fast and also bent the flange lip up.
__________________
1956 Chevy Bel Air 2 door
1956 Chevy 210 4 Door
1970 K20 LWB project the Hulk build w/Supercharged 4.8L-ly2/4L60E HULK BUILD
1970 C10 Yellow/White Deluxe LWB w/ 5.3L-LC9/6L80E
1968 K10 LWB Dark green my son calls it "THE HULK Jr"HULK JR *SOLD*
GO GO!!!
First c10 is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:46 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com