1st Square HELP!! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

greg64 · 10-23-2014, 10:48 PM

One thought that occurred to me... You mentioned that the calipers were changed by the PO. I've had experiences over the years where the wrong caliper was in the correct box. There are a number of calipers with different piston bores that have the same mounting ears. Maybe your two front calipers aren't matched, leading to the left side being weaker.

Also, make sure the front flex lines are in good condition. I've had problems before because the inside of the line had collapsed.

Good luck!

10-23-2014, 10:48 PM	#1
greg64 Registered User Join Date: Dec 2007 Location: Kimberley, BC, Canada Posts: 799	Re: 1st Square HELP!! One thought that occurred to me... You mentioned that the calipers were changed by the PO. I've had experiences over the years where the wrong caliper was in the correct box. There are a number of calipers with different piston bores that have the same mounting ears. Maybe your two front calipers aren't matched, leading to the left side being weaker. Also, make sure the front flex lines are in good condition. I've had problems before because the inside of the line had collapsed. Good luck! __________________ Greg 64 GMC Suburban - 283, NV3500, 14 bolt 77 C10 swb - 292, SM465, 12 bolt

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.