|
12-05-2014, 11:50 PM
|
#26 |
|
Registered User
Join Date: Jun 2013
Location: Somewhere
Posts: 3,151
|
Re: finish it or move on?
My vision isn't the OP's, but if you can afford to keep it, the junk you have is often better.
|
|
|
|
12-06-2014, 10:30 AM
|
#27 |
|
Registered User
Join Date: Mar 2012
Location: Evanston
Posts: 304
|
Re: finish it or move on?
If you guys want to see how hard it's going to be to cut into this 54 look at these pictures! http://m.ebay.com/itm/321318825027?cmd=VIDESC
__________________
My Patinia'd 69 69-http://67-72chevytrucks.com/vboard/showthread.php?t=517537 My RHD 68 http://67-72chevytrucks.com/vboard/s...d.php?t=594928 |
|
|
|
|
12-06-2014, 11:49 AM
|
#28 |
|
Senior Member
 
Join Date: Feb 2001
Location: New Madison, Ohio
Posts: 21,377
|
Re: finish it or move on?
Finish and then start on the 54.
Then you have the best of both wolds. JMHO 
__________________
A husband can be right...or...A husband can be happy.  67-72 Chevy and GMC Trucks...The Classic Truck for the Classic Folk.  1970 CST Two tone green, 402BB, 400 Automatic, Tach, Buckets, AC, AM-FM, Tilt, GM CB, GM 8 Tract, LWB, etc   JOHN 17:3...The better side of "LIFE" Remember: Everyday is a good day...Some are just gooder! |
|
|
|
|
12-06-2014, 12:49 PM
|
#29 |
|
Registered User
Join Date: Nov 2014
Location: Paducah,KY
Posts: 65
|
Re: finish it or move on?
Since you said it's right hand drive,definately finish it. Is it from the UK OR Australia?
|
|
|
|
|
12-06-2014, 12:51 PM
|
#30 |
|
Registered User
Join Date: Mar 2012
Location: Evanston
Posts: 304
|
Re: finish it or move on?
I did the conversion to the truck but it's all up to factory spec other than the different heater switch and heater setup but none of that matters on a full custom build.
__________________
My Patinia'd 69 69-http://67-72chevytrucks.com/vboard/showthread.php?t=517537 My RHD 68 http://67-72chevytrucks.com/vboard/s...d.php?t=594928 |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
