Hub centric rings for 64c10 with disc conversion - The 1947 - Present Chevrolet & GMC Truck Message Board Network

YOLO · 07-11-2015, 02:17 PM

Anyone know what size rings are needed for the front wheels? I am using my stock wheels but did a disc conversion up front. The center bore on the disc is much smaller than the drum. Any help would be great. If you did buy them, where? Website????

**Jurassic-1** · 07-11-2015, 03:10 PM

If you are running stock wheels you should not need the rings since the lug nuts have a conical seat they are centered.

YOLO · 07-11-2015, 03:32 PM

Quote:

Originally Posted by Jurassic-1

If you are running stock wheels you should not need the rings since the lug nuts have a conical seat they are centered.

I agree but....... the wheels fit great over the stock drums but "fit" a little tighter over the disc. I was hoping the ring would help. If not, I will just find 15 inch early 70's stock wheels.

07-11-2015, 02:17 PM	#1
YOLO Custom Truck Lover! Join Date: Nov 2007 Location: Phoenix, AZ Posts: 440	Hub centric rings for 64c10 with disc conversion Anyone know what size rings are needed for the front wheels? I am using my stock wheels but did a disc conversion up front. The center bore on the disc is much smaller than the drum. Any help would be great. If you did buy them, where? Website???? __________________ Squarebody guy

07-11-2015, 03:10 PM	#2
Jurassic-1 Registered User Join Date: Jul 2007 Location: New River Arizona Posts: 1,180	Re: Hub centric rings for 64c10 with disc conversion If you are running stock wheels you should not need the rings since the lug nuts have a conical seat they are centered.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.