WTB factory hard line for rear 4L80 fitting - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Tilt · 08-19-2015, 08:12 PM

I am needing a section of the factory hard line for the trans cooler line that fits the rear (deeper) fitting on a 05 4L80. I just need the part that clips into the fitting with a long enough end to get a compression fitting on. Shipping to 77535. Thanks.

**dayj1** · 08-20-2015, 05:31 PM

Quote:

Originally Posted by Tilt

I am needing a section of the factory hard line for the trans cooler line that fits the rear (deeper) fitting on a 05 4L80. I just need the part that clips into the fitting with a long enough end to get a compression fitting on. Shipping to 77535. Thanks.

I have the tool to create the flare on a piece of steel tubing. How long of a piece of tubing do you need? Do you need the line for just one fitting or both?

Tilt · 08-21-2015, 05:54 AM

Thanks. I found what I was needing.

08-19-2015, 08:12 PM	#1
Tilt Registered User Join Date: Jul 2014 Location: Dayton, TX Posts: 335	WTB factory hard line for rear 4L80 fitting I am needing a section of the factory hard line for the trans cooler line that fits the rear (deeper) fitting on a 05 4L80. I just need the part that clips into the fitting with a long enough end to get a compression fitting on. Shipping to 77535. Thanks. __________________ '83 Silverado Step Side '85 GMC short bed. '86 Chevy Step Side Custom Deluxe LQ9/4L80 swap (SOLD)

08-21-2015, 05:54 AM	#3
Tilt Registered User Join Date: Jul 2014 Location: Dayton, TX Posts: 335	Re: WTB factory hard line for rear 4L80 fitting Thanks. I found what I was needing. __________________ '83 Silverado Step Side '85 GMC short bed. '86 Chevy Step Side Custom Deluxe LQ9/4L80 swap (SOLD)

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.