|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-05-2015, 09:26 AM
|
#1 |
|
Registered User
Join Date: Oct 2015
Location: Keller, tx
Posts: 426
|
Front drop spring recommendation?
PO dropped front of 63 C10 with 2 inch drop springs and also cut an extra 2 inches out of them.
I'm going to install POL disk conversion kit with 2.5 drop spindles and would like to maintain the current height while eliminating the suspension from bottoming out so easily. 1)Can I go with 2.0 drop springs with 2.5 drop spindles? 2)If so, will this pose any problems? ie: suspension bottoming out so easy/limited suspension travel 3)will standard 15" 5x5 rims fit without any issues? (maybe should go with 17"?) sorry for so many questions |
|
|
|
12-05-2015, 05:21 PM
|
#2 |
|
Registered User
Join Date: Sep 2009
Location: California Delta
Posts: 2,163
|
Re: Front drop spring recommendation?
Got Pics?
There are lots of variables so there isn't just one answer so we need more information. What is bottoming exactly? Have the bump stops been cut?
__________________
Name: Rich Current Ride: 1964 C-10 Short Fleetside Daily Driver: 2005 GMC crew cab short fleetside /2001 Chevy Tahoe Past GM Trucks: 1959 GMC short stepside 1968 GMC short stepside-4x4 1973 Chevy short stepside 1989 Chevy short fleetside-reg cab 1993 Chevy short fleetside-Xcab 2002 Chevy short fleetside-Xcab Save the dinosaurs, use synthetic oil. |
|
|
|
|
12-05-2015, 09:18 PM
|
#3 |
|
Registered User
Join Date: Oct 2015
Location: Keller, tx
Posts: 426
|
Re: Front drop spring recommendation?
will try to take some better pic tomorrow. I think the bump stops (if its the correct area that I'm thinking as bump stops, the metal pads directly above the lower A frames). The area I'm trying to describe has only about 1-1.5 inch gap.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
