Heater blower motor resistor question - Page 2 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

tucsonjwt · 12-25-2015, 08:37 PM

How did you get the chrome knobs off? They were staked on with a lot of force at the factory.

68Timber · 12-25-2015, 09:11 PM

Quote:

Originally Posted by tucsonjwt

How did you get the chrome knobs off? They were staked on with a lot of force at the factory.

Wiggle and pull, honestly. Some are on better than others. Those three I used were the best off the controls I bought and the one that was on the truck. The levers have barbs on the sides, so wiggle the knobs side to side while pulling to free it.

12-25-2015, 08:37 PM	#26
tucsonjwt Registered User Join Date: Jul 2007 Location: Tucson, AZ Posts: 3,191	Re: Heater blower motor resistor question How did you get the chrome knobs off? They were staked on with a lot of force at the factory.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.