|
01-23-2016, 07:44 PM
|
#1 |
|
Old member
Join Date: Jan 2002
Location: Liberty, & Garden City S.C. , U.S.
Posts: 19,945
|
Vacuum port
Have any of you seen this. I ran across it on FB today for shaved intakes.
This will t off the back port. And give you multiple lines for b as vacuum source or boost source etc. Map sensor runs off a tiny vacuum line so you can hook one straight to the bottom and will work fine. Here is the website.  http://www.full-race.com/store/acces...ost-block.html
__________________
1971 LWB Custom, 6.0LS & 4L80E, Speedhut.com GPS speedometer & gauges with A/C. 20" Boss 338's Grey wheels 4 wheel disc brakes. My Driver Seeing the USA in a 71 Upstate SC GM Truck Club 2013,14 and 2016 Hot Rod Pour Tour http://upstategmtrucks.com/ Get out and drive the truck this summer and have some fun! It sucks not being able to hear! LWB trucks rule, if you don't think so measure your SWB! After talking to tech support at Air Lift I have found out that the kit I need is 60811. Per the measurements I gave them. Ride height of truck inside spring and inside diameter of springs. |
|
|
|
01-23-2016, 08:19 PM
|
#2 |
|
Registered User
Join Date: Jul 2012
Location: Anderson,SC
Posts: 953
|
Re: Vacuum port
We used these a lot back when I ran Hondas. We always bought much cheaper ones though. Full race is a great company that puts out a quality product, but in this case half of the price is the sticker on the front. That doesn't do much good when you are trying to hide those lines. I'll probably have Eric do a shaved manifold for me and use something like this.
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
