installing rear motor mounts - The 1947 - Present Chevrolet & GMC Truck Message Board Network

mehoff400 · 01-23-2016, 07:34 PM

i am in the process of installing these rear motor mounts http://www.classicparts.com/1954-72-.../#.VqQNsFmYLlg the issue i am having is i cant get the bigger U shaped mount to fit into the hole. i have tried putting a bolt through the mount and compressing it down. but unbolted it and it just seemed to cut into the mount. any tips?

OldChevy61 · 01-23-2016, 10:23 PM

The bigger piece goes between bell housing and cross member facing down. Small piece goes in the cross member bottom side . Bolt should go right in. Get both sides in before tightening in case you have to shift it a little.. Never seen those give a problem.

01-23-2016, 07:34 PM	#1
mehoff400 Registered User Join Date: Apr 2015 Location: Puyallup WA Posts: 365	installing rear motor mounts i am in the process of installing these rear motor mounts http://www.classicparts.com/1954-72-.../#.VqQNsFmYLlg the issue i am having is i cant get the bigger U shaped mount to fit into the hole. i have tried putting a bolt through the mount and compressing it down. but unbolted it and it just seemed to cut into the mount. any tips?

01-23-2016, 10:23 PM	#2
OldChevy61 Registered User Join Date: Apr 2015 Location: NICHOLS SC Posts: 435	Re: installing rear motor mounts The bigger piece goes between bell housing and cross member facing down. Small piece goes in the cross member bottom side . Bolt should go right in. Get both sides in before tightening in case you have to shift it a little.. Never seen those give a problem.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.