Rear main (crankshaft) seal question - The 1947 - Present Chevrolet & GMC Truck Message Board Network



Register or Log In To remove these advertisements.

		The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Engine & Drivetrain > LSx Swaps
Rear main (crankshaft) seal question

Site Merchandise

Thread Tools

Display Modes

05-13-2016, 11:29 AM

MattPSU

Registered User

Join Date: Nov 2011

Location: Lyman, SC

Posts: 734

Re: Rear main (crankshaft) seal question

Quote:

Originally Posted by ls1nova71

As long as you don't take the rear cover off, you won't need the alignment tool. If you do take the rear cover off then the tool is needed to align it up since it has no aligning tabs made onto it. The tool does make it easier to install the new seal though.

Thanks! That confirms that I thought. I appreciate it sir!

__________________
Matt Criswell - Lyman, SC

1972 Chevy Cheyenne SWB - Build: Porterbuilt State 1 Front & Rear, Bolt in Notch, McGaughys 2.5 Drop Spindles, Boyd Welding Fuel Tank

UPSTATE SC GM TRUCK CLUB: FACEBOOK WEBSITE

Bookmarks

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 12:23 PM.

Register or Log In To remove these advertisements.