|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-09-2016, 02:34 PM
|
#1 |
|
Registered User
Join Date: Aug 2011
Location: Onaway michigan
Posts: 5
|
Carrier bearing drive shaft to 1 piece drive shaft conversion
I have a 1974 long bed c10 that I am going to be lowering and was wondering if anyone has switched from a carrier bearing drive shaft to a one piece? If so is there a factory one piece drive shaft that I might be able to use rather than haveing one built, any help would be much appreciated.
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
