Jeep tank blazer unit

[tmills213]

So I decided to go with the jeep tank since it is supposed to be easy to install and no major mods really needed. yes its small but I don't drive that far so I don't mind. After looking and looking and trying to follow closely what others have done, I bought the 87 blazer sending unit and I notice the float hits. since orientation is fixed on top, what are you guys doing?

[tmills213]

I dont know how I feel about bending it 90 either.

[Green67Stepper]

i think there is two different sizes for the blazer sending unit. A 20+ gal and a 30+ gal one. maybe you got the bigger one?

[tmills213]

Part number fg12k. Not sure

Originally Posted by Green67Stepper

i think there is two different sizes for the blazer sending unit. A 20+ gal and a 30+ gal one. maybe you got the bigger one?

Posted via Mobile Device

[tmills213]

I did find this in another post:

"Yes, I plan on just capping off the unused return line. The Blazer sending unit is 0-90 ohms so it will work fine with earlier fuel gauge setups.

The only thing I needed to modify on the sender was to cut the locking tabs off. They were putting the sender in the jeep tank at a location that was causing the float to hit the internal baffle of the tank. With the two tabs cut off I could turn the sender unit to center the float in the tank."
Posted via Mobile Device

[michael bustamante]

i tried using the 30 gallon at first and it stuck up about 2.5 inches. i frankensteined it.... decided it looked like sh%t and bought a 25 gallon.