|
04-13-2004, 08:16 AM
|
#3 |
|
Registered User
Join Date: Apr 2000
Location: Leesburg, GA
Posts: 746
|
It can be done. There was a magazine article a few years back that showed how one person did it. In the article they put the poly bushing in a lathe and dug/cut a small groove in the center (to give the grease access all around the bushing) and then drilled a hole in the center of the bushing housing and installed a zerk fitting. I have not installed my poly trailing arm bushings yet so I don't know if I will add a zerk fitting or not.
__________________
FOUNDING MEMBER OF THE DRUM BRAKE CLUB Second Owner 70 C-10 Second Owner 93 GMC C1500 Third Owner 99 C2500 Crew Cab Short Bed |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode