700R4 input shaft - The 1947 - Present Chevrolet & GMC Truck Message Board Network



Register or Log In To remove these advertisements.

		The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board
700R4 input shaft

Site Merchandise

Thread Tools

Display Modes

10-23-2018, 09:43 PM

Bloodhound

Registered User

Join Date: Dec 2011

Location: Massachusetts

Posts: 249

Re: 700R4 input shaft

Quote:

Originally Posted by GRADYS Performance

That 1 1/8" figure will vary a little bit case to case and converter to converter. it sounds like the converter is all the way in thee trans. When you bolt the motor and trans together make sure you have at least 1/8" between converter and flexplate.

Ok good to know it's not a hard and fast rule. Tomorrow night Ill line them up and see where it's at.

Bookmarks

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 11:04 PM.

Register or Log In To remove these advertisements.