The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1947 - 1959 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 11-25-2018, 11:21 PM   #1
whitedog76
Registered User
 
Join Date: Jan 2014
Location: Peoria, IL
Posts: 1,450
Re: Welding MII boxing plates

Well, I got them welded in. A little clean up and grinding, then we’re ready for the crossmember. I did bolt a piece of tube steel across the front also. I had previously notched the factory crossmember where the 235 motor mount was. Anyhow, I trimmed and cleaned it up. Anyhow, everything stayed nice and square.

Speaking of crossmembers... during a cooling cycle, I cut some plate and welded it in to take up the gap. Basically, I just boxed the backside of the crossmember upright.

Moving forward.
whitedog76 is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 05:09 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com