|
something else: The u-joints, while all spicer 1310 type, have different NAPA P/N and the only difference I see is the grease fitting. The two for the double cardian (379) have the fitting coming out of the center at an angle while at the axle end (369) the grease fitting goes straight in the center. Also I marked the H-yoke but it appears to go either way. If I buy the centering yoke do you think it comes with the small parts?
__________________
1970 K25, 8' stepside bed 350/465/205 44 up front, 60 in the rear 4.10s rolling on 33" Dunlop MTs
1986 K5, 350/465/208 Dana 60/14 bolt from a cucv 36" Super Swampers TSL/SX
1983 K20 w/ CUCV axles, 350/700R4/208 sitting on 37" Goodyears
1986 M1031 6.2 diesel, TH400/NP205 locker in the rear and a LS in the front, all stock for now.....
1986 K30, 350/400/205 dana 60 and 14 bolt. I kept the drivetrain. Body/bad and chassis are gone.
1981 K30, 350/465/205 dana 60 and dually 14 bolt. Has a G80, and a flat bed. Going to replace the flat bed.
1985 K20, 350/400/208 10 bolt and SF 14 bolt. I wonder where I can find some 1 tons. Hmmmmm 
|
05-20-2004, 06:11 AM
Hybrid Mode
