Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
01-25-2019, 09:04 PM | #1 |
Registered User
Join Date: Oct 2018
Location: Trenton MO
Posts: 201
|
Replacing A Dash
Ok, so I have found a pretty good "low Rust" cab for my 1947 5 window. The only trouble is - someone in it's past life has put a homemade dash in it (good job - ugly dash). My question is - how hard would it be to remove the dash from my original "swiss cheese" cab, and put it in the "new" cab? I have seen the dashes for sale, but don't have the cash for one just yet. How feasible is it to remove mine, and put it in the other cab? Am I better off going with an aftermarket or should I attempt it.
I've done a search, and came up with anything from "easy", to "impossible".... |
01-25-2019, 09:16 PM | #2 |
Post Whore
Join Date: May 2015
Location: Alabama
Posts: 14,670
|
Re: Replacing A Dash
its been done by several in the project section...got any pics of what your wanting to pull out?...
__________________
Mongo...aka Greg RIP Dad RIP Jesse 1981 C30 LQ9 NV4500..http://67-72chevytrucks.com/vboard/s...d.php?t=753598 Mongos AD- LS3 TR6060...http://67-72chevytrucks.com/vboard/s...34#post8522334 Columbus..the 1957 IH 4x4...http://67-72chevytrucks.com/vboard/s...63#post8082563 2023 Chevy Z71..daily driver |
01-25-2019, 09:43 PM | #3 |
Registered User
Join Date: Oct 2018
Location: Trenton MO
Posts: 201
|
Re: Replacing A Dash
I'm on a borrowed computer, so I couldn't do a thorough search (and I can't post photos). I have not seen the dash in person, but BIL has, and sent me a photo via Facebook. It looks like they bent a sheet of metal and installed it where the old dash was. It has a "flat face" the full width on the front (where the gauges would be). No openings for radio/gauges/etc have been cut yet.
|
01-26-2019, 05:08 AM | #4 |
Registered User
Join Date: Jul 2007
Location: Toppenish, WA
Posts: 15,711
|
Re: Replacing A Dash
The dash is held in with spot welds every few inches across the top lip an connected to the cab at a couple of spots on the upper kick panels.
You can either sit in the Swiss cheese cab and drill out spot welds or you could cut across the cowl , through the corners of the windshield frame just outside the ends of the dash and take it loose under the dash and take it into the work bench or saw horses and sit comfortably while you cut the spot welds out. This shot of the inside of one of my cabs that I cut the dash out of for someone to salvage part of shows the bracket with the two bolts that hold the lower part of the dash (orange arrow). I don't think the side of the dash is fastened to the cab down that edge.
__________________
Founding member of the too many projects, too little time and money club. My ongoing truck projects: 48 Chev 3100 that will run a 292 Six. 71 GMC 2500 that is getting a Cad 500 transplant. 77 C 30 dualie, 454, 4 speed with a 10 foot flatbed and hoist. It does the heavy work and hauls the projects around. |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|