63 door alignment issues

[Rusty one]

Originally Posted by PGSigns

Yup get the frame on jack stands and level it up. Get a new set of body bushings and install them. Make sure they are all pulled down the same. Take a good look at the cab supports to make sure they are not sagging. If they are rotted at the rocker the rocker and that side of the floor can sag. If that cab corner was bent up before it was filled up with bondo then that could have the door opening out of square. Right now I think you cab is sagging and the door opening is no longer the shape of the door.
Jimmy

Jimmy..

One of the cab supports has a small rot hole but ill be replacing it as well as the cab corners, rockers and the bushings. It's supported on jack stands on the rails. The other door I replaced fits without issues.
I'll do the best I can and post progress pics..
Thankyou for your advice