More RH inner fender (skirt) stuff - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**71CHEVYSHORTBED402** · 07-30-2019, 10:53 PM

Couple discussions out there, I thought to throw this into one spot. This is an NOS RH inner fender. It showed up with two nice dings on top. Seeking recourse, I want to use it. Unless someone suggests differently, looks like they're not difficult to straighten out, I'll let the body man do it

Worst of the dings shown, the other isn't too bad.

Word is the ground strap always fastens to the pre-drilled hole located near the front inside corner of the fender. This new fender has that hole,as do my other RH fenders. Probably a fluke, but the strap was fastened to the exact same spot on both of my 402 trucks, located closer to the frame rail instead. This NOS fender does not have a "drill dimple" nor a hole at this location.

On a side, my original RH skirt has very small/faint stamps at two locations. This new one doesn't, and neither did my LH fender. Who knows.

Other than that some captions.

07-30-2019, 10:53 PM	#1
71CHEVYSHORTBED402 Senior Member Join Date: Feb 2009 Location: Northern Nevada Posts: 7,385	More RH inner fender (skirt) stuff Couple discussions out there, I thought to throw this into one spot. This is an NOS RH inner fender. It showed up with two nice dings on top. Seeking recourse, I want to use it. Unless someone suggests differently, looks like they're not difficult to straighten out, I'll let the body man do it Worst of the dings shown, the other isn't too bad. Word is the ground strap always fastens to the pre-drilled hole located near the front inside corner of the fender. This new fender has that hole,as do my other RH fenders. Probably a fluke, but the strap was fastened to the exact same spot on both of my 402 trucks, located closer to the frame rail instead. This NOS fender does not have a "drill dimple" nor a hole at this location. On a side, my original RH skirt has very small/faint stamps at two locations. This new one doesn't, and neither did my LH fender. Who knows. Other than that some captions. Attached Images __________________ Tony 71 Custom Deluxe, SWB, 2WD, 402, A/C. I developed an assembly guide (kit) for restoring this truck from the ground up, complete with details including full hardware descriptions. Much of the info. applies to all 67-72 GM. My build thread, with some info. about the assembly kit https://67-72chevytrucks.com/vboard/...d.php?t=730025 Last edited by 71CHEVYSHORTBED402; 07-31-2019 at 12:41 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.