|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
01-19-2020, 08:42 PM
|
#5 |
|
Senior Member
 
Join Date: Jan 2011
Location: Hayes Va
Posts: 4,569
|
Re: Anybody with cpp 4° lowering blocks?
Best way to determine what degree shim or block you need is to measure. When I did the lowering on the 66 I put it on ramps all round and with the weight on the suspension went under and measured the angle at both ends of the drive shaft to see where I was at. I then machined the 1" blocks I was using to the angle I needed. Put 3 degrees on the top of the blocks.
Jimmy
__________________
60 to 66 Chevy and GMC window decals http://67-72chevytrucks.com/vboard/s...d.php?t=661131 Good friends, good food and a hotrod what else do you need? 1966 BBW long fleet Daily driver 1965 BBW short fleet Sold and going to a good home 1965 Suburban 2003 3500 Duramax 2005 Ultra Classic |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode