47-59 Driveshaft - transmission tail piece - Page 2 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**TX3100Guy** · 12-07-2022, 09:57 PM

Quote:

Originally Posted by dsraven

that angle may change slightly with a longer shaft due to the trans end going further forward. should be a minor cange though

I'll know more tomorrow if its gonna be a new drive shaft or elongating mine. Seems the guy at the shop has a 49 GMC so he knew exactly what I was talking about.

dsraven · 12-07-2022, 09:58 PM

that always helps.

**mr48chev** · 12-07-2022, 11:41 PM

The only to make a drive shaft longer is replace the complete tube. You can't add in a section to lengthen them.

mick53 · 12-08-2022, 04:11 PM

It's been about ten years since I had a driveline shop retube one of my dump truck driveshafts. It was $40.

**mr48chev** · 12-08-2022, 07:27 PM

Local prices differ a bunch but around here a guy is looking at somewhere bettween 1 and 2 hundred to have just the tube replaced. That is at a drive shaft shop that can balance the driveshaft right.

12-07-2022, 09:58 PM	#27
dsraven Registered User Join Date: Nov 2010 Location: calgary alberta Posts: 8,372	Re: Driveshaft - transmission tail piece that always helps.

12-07-2022, 11:41 PM	#28
mr48chev Registered User Join Date: Jul 2007 Location: Toppenish, WA Posts: 15,731	Re: Driveshaft - transmission tail piece The only to make a drive shaft longer is replace the complete tube. You can't add in a section to lengthen them. __________________ Founding member of the too many projects, too little time and money club. My ongoing truck projects: 48 Chev 3100 that will run a 292 Six. 71 GMC 2500 that is getting a Cad 500 transplant. 77 C 30 dualie, 454, 4 speed with a 10 foot flatbed and hoist. It does the heavy work and hauls the projects around.

12-08-2022, 04:11 PM	#29
mick53 Registered User Join Date: Oct 2018 Location: Warsaw IN Posts: 897	Re: Driveshaft - transmission tail piece It's been about ten years since I had a driveline shop retube one of my dump truck driveshafts. It was $40.

12-08-2022, 07:27 PM	#30
mr48chev Registered User Join Date: Jul 2007 Location: Toppenish, WA Posts: 15,731	Re: Driveshaft - transmission tail piece Local prices differ a bunch but around here a guy is looking at somewhere bettween 1 and 2 hundred to have just the tube replaced. That is at a drive shaft shop that can balance the driveshaft right. __________________ Founding member of the too many projects, too little time and money club. My ongoing truck projects: 48 Chev 3100 that will run a 292 Six. 71 GMC 2500 that is getting a Cad 500 transplant. 77 C 30 dualie, 454, 4 speed with a 10 foot flatbed and hoist. It does the heavy work and hauls the projects around.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.