|
Re: Hood to Fender Alignment Questions
If your front to back sitting pretty close, I thinking your hood is bent lightly. I would open and check the under side hood on both side to see if cracked had a fold crease around the high spots if it has not got and crease in it yet. you can use a 2x4x4' and some towels to message the top down a little be gentle small blows lots light and check a lot so you do not go to far. **If it is creased your going to need a new hood. (or can try the hood brace for the 73-80 hoods). You may need piece 2x4 under the hood if it not moving at all in the few blows.
__________________
 1977 REG cab Long Bed with a 1984 Front Clip, 82 305 .60 over 9.0.1 flat top pistons, 4bbl, TH350, w/84 SS-intake & cam , w/ 1977 big block rad, 1975 gear box, 1984 master w/ metric fittings top & SAE fitting @ portion block, 1975 3.42 gear open diff. Duel 77-87 Factory air cleaner, duel inlet from rad support . Down sized 9' to new 8' Steel flat bed
Was a 77 454 w/308 gear. Taken out 550 lbs. up front with motor clip change.
|
12-22-2022, 02:17 AM
Threaded Mode