|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-22-2023, 12:15 AM
|
#1 |
|
Registered User
Join Date: Jun 2013
Location: Colorado Springs, Colorado
Posts: 20
|
Tri-Five Header on 67-72 C10
I have been wondering for some time if anyone has tried using SBC headers meant for 55-57 Chevy{Car} on their 67-72 C10?
SUM-G9103 headers are a set I am specifically asking about. I am running a 350/700r4, custom engine and tranny mounts, and is set back about as far as possible without firewall mods. Thanks in advance!
__________________
1969 C10 SWB, 68 Front Clip, Tired azz 350 w/built 700R4, 3.73 Peg Leg........... |
|
|
|
11-24-2023, 01:06 PM
|
#2 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
Re: Tri-Five Header on 67-72 C10
I think that you will have a problem with the front tubes contacting the eng mounts or cross member under the engine? If you look in summits site,under headers for you truck (67-72), Hooker comps ( HOK-2452 HKR) you will see an example on how the front tubes go over the top & drop to the center & rear for clearance up front. These headers fit nice & tuck up pretty good. the collectors hang just about 2 - 2 1/4 inches below the frame rails. If you can post pics of your mounts.....some others may have suggestions
 Longhorn (the crazy fab nut)
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
