Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
09-13-2004, 11:30 PM | #1 |
Registered User
Join Date: Aug 2004
Posts: 6
|
what to do to make front cross member lay flat?
as of now my 66 has bags on front without drop spindles. with no air in bags the front crossmember measures 5 1/4 off ground. i realize with 3 inch drop spindles the cross member will then measure 2 1/4 off the ground. what are yall guys doing to make crossmember lay flat?
|
09-14-2004, 01:41 PM | #2 |
Seņor Member
Join Date: May 2002
Location: Edge of the world
Posts: 5,367
|
You can get another 1.5" here... http://67-72chevytrucks.com/vboard/s....php3?t=108091
__________________
|
09-14-2004, 07:29 PM | #3 |
Registered User
Join Date: Aug 2004
Posts: 6
|
XXL that would lower the truck 1.5 but i need to rework the bags or some thing to allow the a arms to travel up more to make the cross member go lower than it is. so i was wondering if other trucks was laying the front cross member or what?
|
09-15-2004, 01:07 AM | #4 |
Under construction!
Join Date: Aug 2002
Location: NorCal
Posts: 1,065
|
You need to section the front X-member and add spindles to lay it out flat. W/O a sectioned X-member, the LCA's will always make contact w/ the pavement first.
__________________
2001 Silverado bagged on 22's. *Sold* |
09-15-2004, 07:56 PM | #5 |
Registered User
Join Date: Aug 2004
Posts: 6
|
do ya have any pics of one sectioned
|
09-15-2004, 11:33 PM | #6 |
Under construction!
Join Date: Aug 2002
Location: NorCal
Posts: 1,065
|
Check out the link posted above and the HUGE X-member thread in this forum section for more pictures/information.
__________________
2001 Silverado bagged on 22's. *Sold* |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|