My camaro tach cluster-done! - Page 2 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

edman87 · 02-03-2008, 07:57 AM

I finally got my cluster together! Removed gas guage, put a tach from a 86 z28 in its place. Originally the camaro tach had the oil pressure gauge in the corner, swapped it with the camaro fuel gauge. It fit with a little dremel work. Also installed a NOS clock in the vacant location. Reset the odo to 0 miles. Used the cluster from my 89 parts blazer because it has the trip odo. The knobs for the trip odo and clock are aluminum tire valve caps with the end of a sports ball inflator needle screwed in them, then drilled and tapped for a 6-32 set screw. Pics below. Whatcha think??

Pictures no longer available.
Forum Staff

02-03-2008, 07:57 AM	#1
edman87 junk collector Join Date: Dec 2004 Location: above Baton Rouge, LA Posts: 693	My camaro tach cluster-done! I finally got my cluster together! Removed gas guage, put a tach from a 86 z28 in its place. Originally the camaro tach had the oil pressure gauge in the corner, swapped it with the camaro fuel gauge. It fit with a little dremel work. Also installed a NOS clock in the vacant location. Reset the odo to 0 miles. Used the cluster from my 89 parts blazer because it has the trip odo. The knobs for the trip odo and clock are aluminum tire valve caps with the end of a sports ball inflator needle screwed in them, then drilled and tapped for a 6-32 set screw. Pics below. Whatcha think?? Pictures no longer available. Forum Staff __________________ '87/89/76 K5 in progress '99 K2500 short crew '91 camaro rs '98 jeep tj '52 willys cj3a Last edited by oldiron; 08-30-2010 at 02:29 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.